Manuals / Bunn / Kitchen Appliance / Coffeemaker

Bunn H10X manual User Notices, 00656.0000, 00831.0000, 37881.0000, Electrically ground the chassis

Models: H10X

1 20

Download 20 pages 6.76 Kb

Page 3

USER NOTICES

USER NOTICES

Carefully read and follow all notices on the equipment and in this manual. They were written for your protec- tion. All notices are to be kept in good condition. Replace any unreadable or damaged labels.

12593.0000

This equipment must be installed to comply with the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Adminis- tration (FDA). For models installed outside the U.S.A., comply with the applicable Plumbing /Sanitation Code.

00656.0000

!WARNING

Fill water tank before turning - on - thermostat or connecting appliance to power source.

Use only on a properly protected circuit capable of the rated load.

Electrically ground the chassis.

Follow national/local electrical codes.

Do not use near combustibles.

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE, OR SHOCK HAZARD

READ THE ENTIRE OPERATING MANUAL BEFORE BUYING OR USING THIS PRODUCT

THIS APPLIANCE IS HEATED WHENEVER

CONNECTED TO A POWER SOURCE

00831.0000F 3/98 ©1998 BUNN-O-MATIC CORPORATION

00831.0000

37881.0000

12537.0000

3	10889 021408

Image 3

Bunn H10X manual User Notices, 00656.0000, 00831.0000, 37881.0000, Electrically ground the chassis, 10889

Contents

10889.0000E 02/08 1995 Bunn-O-Matic Corporation H10XBUNN-O-MATIC CORPORATION POST OFFICE BOX SPRINGFIELD, ILLINOIS PHONE 217 529-6601 FAXBUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY 00656.0000 USER NOTICESREAD THE ENTIRE OPERATING MANUAL BEFORE BUYING OR USING THIS PRODUCT THIS APPLIANCE IS HEATED WHENEVER CONNECTED TO A POWER SOURCEPlumbing Hook-Up ELECTRICAL REQUIREMENTSPLUMBING REQUIREMENTS Electrical Hook-UpDRAINING THE DISPENSER CLEANINGCE REQUIREMENTS INITIAL SET-UPREMEDY TROUBLESHOOTINGPROBLEM PROBABLE CAUSEREMEDY TROUBLESHOOTING contPROBLEM PROBABLE CAUSEInspect the tank assembly for excess TROUBLESHOOTING contPROBLEM Temperature controlSERVICE Component Access10-14 Check these items first SERVICE cont Electronic Control Assembly TroubleshootingSERVICE cont Electronic Controls cont If voltage was present as described, proceed to #4. If voltage was not present as described, refer to the Wir- ing Diagram and check the dispenser wiring harness SERVICE cont Electronic Controls cont8. Reconnect the wires 9. Review the initial set-up procedures SERVICE cont Electronic Controls cont12. Replace the triac assembly 7. Fasten the new electronic control assembly to its bracketTriac Assembly Removal and Replacement SERVICE cont Electronic Controls contBLK to Terminal Block Reset BLK to Tank Heater SERVICE cont Limit Thermostat Limit ThermostatFIG. 7 OVERFLOW PROTECTION SWITCH SERVICE cont Overflow Protection SwitchP1994 SERVICE cont Solenoid ValveSERVICE cont Solenoid Valve cont BLU to Triac Assy SERVICE cont Tank HeaterP101 WIRING DIAGRAM SCHEMATIC WIRING DIAGRAM H10XA2 WIRE + GND SINGLE PHASE 200-240 VOLTS AC