SERVICE (cont.)
START SWITCH
4.Check for continuity across the two terminals on the left side of the switch when it is held in the lower position. Continuity must not be present across these terminals in the upper position.
If continuity is present as described, reconnect the wires, the switch is operating properly.
If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Remove the wires from the switch terminals.
2.Compress the clips inside the hood and gently push the switch through the opening.
3.Push the new switch into the opening and spread the clips to hold the switch captive in the hood.
4.Refer to Fig. 23 when reconnecting the wires.
WHI/ORN to Hot |
| ORN to Iced Tea | ||
Tea Brew Timer TL3 |
| Brew Timer TL3 | ||
|
|
|
|
|
|
|
|
|
|
WHI/YEL to |
|
Hot Tea Brew | YEL to Iced Tea |
Timer TL5 | |
| Brew Timer TL5 |
| P1370.40 | |
FIG. 22 START SWITCH | ||
| ||
| ||
|
|
Location:
The start switch is located in the front of the hood, above and to the right of the brew funnel.
Test Procedure:
1.Disconnect the brewer from the power source.
2.Remove the wires from all four terminals.
3.Check for continuity across the two terminals on the right side of the switch when it is held in the lower position. Continuity must not be present across these terminals in the upper position.
If continuity is present as described, proceed to #4. If continuity is not present as described, replace the switch.
FIG. 23 START SWITCH TERMINALS
P1368
Page 27
28201 081598
