Bush Hog 300 3. TRACTOR REQUIREMENTS

OPERATION

300 Series 09/10 Operation Section 4-5

OPERATION

3. TRACTOR REQUIREMENTS

Operating the blade with a tractor that does not meet the following requirements may cause tractor or blade

damage and be a potential danger to the operator and passersby.

• ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

• Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield

• Tractor Horsepower (Drawbar):

- Front Wheel ......................... 12’ - 300 HP, 14’ - 250 HP

• Hitch - 3 Point Hitch.........................CAT III-IV and QH

- Lifting Capacity .................... 12’- 3463 lbs., 14’- 3603 lbs.

• Front End Weights............................As needed to maintain 20% weight on front axle

The power required to operate a blade is determined by the tractor PTO horsepower. For most operating

conditions, the 300 Series rear blade requires a tractor with at least 300 HP for 12’ and 250 HP for 14.’

Operating the blade with a tractor that does not have adequate power may damage the tractor engine.

Exceeding the recommended horsepower may cause blade damage by overpowering the unit in heavy

operating conditions.

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat

belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be

crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.

Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an

authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll-

over-protective system (ROPS). Always wear seat belts. Serious injury or

even death could result from falling off the tractor--particularly during a turnover

when the operator could be pinned under the ROPS. (SG-7)