Small Office Remote Access Switch 71
IP R
OUTING
N
ETWORK
WITH
PPP D
EVICES
Configure SITE1
The following screen will be display ed after all information for device SITE2 has been entered:
Now that device SITE2 has been configured, we can add the needed static route:
• Return to the Main Menu.
• Press 2 to display the Options Menu.
• Press 2 to display the IP Routing Menu.
• Press 3 to add a static route.
CONFIGURING STATIC ROUTES
SITE1 requires one static route. This static route will give SITE1 access to SITE2 and its ass ocia ted
resources. The diagram below illustrates this needed static route, and also the default route needed
by SITE2 to gain access to SITE1 and its associated resources.
To begin the static route configuration, press 3 at the IP menu, then press 1 to add a Static Route.
First, you will be asked if the route is the defa ult route. Press N when asked if this is the de fault
route.
Next, enter the destination IP address of the network to which you want to connect. You should
enter SITE2’s LAN Interface IP address 128.3.0.0.
After you enter the IP address of the LAN, you will be prompted for the Subnet Mask for the
address. Press <return> to accept the default of “16” significant bits.
You will then be prompted for the Next Hop device name for the static route. The Next Hop dev ice
name names the device that provides acce ss to the network on which SITE2 resides. For th is static
route, SITE2 is the Next Hop. Because we have configured an IP WAN unnumbered interface for
SITE1 and SITE2, SITE2 is an unnumbered link for SITE1. For un n u mbered l inks you should enter
0 for the Next Hop address. This interface will provide the gateway to this network.
When prompted, enter SITE2 as the device name of the next hop device.
Current Device Table (Sorted by Device Name in Ascending ASCII Order)
id DEVICE NAME
-----------------------------
1 "SITE2"
(1) Add, (2) Change, (3) Delete, (4) Display a Device or press <RET> for previous
menu?