Cabletron Systems 150

Small Office Remote Access Switch 89

IPX R

OUTING

ETWORK

Configure IPX Routing: Masternet (Detroit)

You will then be asked for the IPX external network number for the LAN interface. Enter 0100.

For the rest of the prompts, press <RET> to accept the default values (including the default values

for the LAN RIP information).

Add a Remote LAN Interface

After completing the LAN interface config uration, select Add to a dd the next inter face for the

Remote LAN. Configure the information for the WAN (Remote LAN) interfa ce as follows:

Note that the IPX N etwork Numb er in the above screen refers to the extern al n etwo rk nu mber of th e

Remote LAN (i.e., the bridged sites).

The following menus will be presented if the IPX RIP/SAP protocols are enabled for the system.

For Remote LANs, the remote peer (bridge) is not expected to understand RIP/SAP protocols. In

the event that the remote peer does understand these protocols, we suggest the following

configuration: do not send, receive, and respond. This will allow the remote peer to see NetWare

services when the remote bridge is connected. When not connected, the services will age-out and

eventually go away.

The RIP/SAP menus will appear similar to the following:

1) LAN

2) WAN (Remote LAN)

Select function from above or <RET> for previous menu:

INTERFACE NAME or <RET> to cancel ?

remotelan

Enter the hexadecimal IPX Network Number or <RET> to cancel ?

0128

Enter the packet encapsulation type

1) Ethernet_II

2) Ethernet_802.2

3) Ethernet_802.3

4) Ethernet_SNAP

[default = ETHERNET_802.2] ?

Enter the MTU size in bytes [default = 1497]? <RET>

RIP Send Control:

1) Do Not Send.

2) Send.

Enter a RIP Send Control from the above menu [default = 2]? 1

RIP Receive Control:

1) Do Not Receive.

2) Send.

Enter a RIP Receive Control from the above menu [default = 2]? 2

RIP Respond Control:

1) Do Not Respond.

2) Send.

Enter a RIP Respond Control from the above menu [default = 2]? 2