Installing the 9Cx14 Chassis

P S

 

 

W N

 

 

R B

 

 

STATUS

-SECURED

SECURED

100%

 

NON

 

Load 50%

 

 

9C214-1

 

 

0%

 

 

POWER SUPPLY MODULE

 

9C614

 

 

 

NON-SECURED

SECURED

100-125v-12A

 

INB

50-60 Hz

 

Termination

200-250v-6A

 

 

 

 

Connectors

Figure 1-7. Attaching the INB Terminator Modules

Powering up the SmartSwitch 9000

The SmartSwitch 9000 chassis is powered up by following the steps below:

1.Plug one end of the power cord (supplied with the power supply) into the AC power socket on the lower right front corner of the power supply.

2.Plug the other end of the power cord into an AC receptacle. Turn on the power supply using the switch located near the power socket.

3.The power supply uses a soft start feature and does a pre-power diagnostic check. Outputs become enabled within 5 seconds of turning the power on.

4.Check that the PWR and SMB LEDs on the power supply are green.

If the LEDs are any color other than green, refer to the Power Supply User’s Guide.

1-15

Page 23
Image 23
Cabletron Systems 9C114, 9000 manual Powering up the SmartSwitch, Attaching the INB Terminator Modules