Rack Mounting the Chassis | Cabletron Systems 9C114, 9000 manual

Installing the 9Cx14 Chassis

Rack Mounting the Chassis

The chassis can be mounted in a standard 19-inch equipment rack. If the rack is not secured to the ﬂoor, it is recommended that the SmartSwitch 9000 be installed in the bottom half of the rack. This will prevent the rack from being top heavy. Two people may be required to lift the chassis into place.

The chassis is secured with twelve bolts, six on each side. Using the bolts provided with the rack, bolt the chassis to the rack, starting with the bottom holes and working up, as shown in Figure 1-2.

1125_05

Figure 1-2. Rack Mounting the Chassis

1-7

Image 15

Cabletron Systems 9C114, 9000 manual Rack Mounting the Chassis

Contents

SmartSwitch 9C114 and 9C714 Chassis Installation Guide Page Page FCC Notice Vcci NoticeIndustry Canada Notice European Representative Address Declaration of Conformity AddendumPage Contents Contents Features SmartSwitch Flexible Network Bus Descriptions of the seven backplane buses are as follows Your email address Getting Help Required Tools InstallationUnpacking the SmartSwitch 9000 Chassis Site Guidelines Installation Order Rack Mounting the Chassis Rack Mounting the Chassis Installing a Power Supply Installing a Power Supply Attaching the ESD Wrist Strap Attaching the Electrostatic Discharge ESD Wrist Strap Installing the Environmental Module Installing the Environmental Module Installing SmartSwitch 9000 Interface Modules Installing SmartSwitch 9000 Interface Modules Attaching 9C614 INB Terminator Modules Attaching the INB Terminator Modules Powering up the SmartSwitch 9C114 MMAC-Plus Chassis Operating SpeciﬁcationsEnvironmental Requirements Regulatory Compliance 9C214-1 Power Supply 9C714 MMAC-Plus Chassis9C300-1 Environmental Module 9C614 INB Terminator Module