Cabletron Systems BRIM-E100

Installing Fast Ethernet Interface Modules

BRIM-E100 User’s Guide Page 3-3

4. Remove the two faceplate screws from the BRIM-E100. See

Figure 3-2.

5. Remove the faceplate.

Figure 3-2 Removing the Faceplate

CAUTION

Failure to remove the BRIM-E100 faceplate before installing

the Fast Ethernet Interface Module may result in damage to the

BRIM-E100 and/or the Fast Ethernet Interface Module.

1665_10

BRIM-E100

book Page 3 Friday, April 19, 1996 9:53 AM

Contents

Main BRIM-E100 Users Guide i NOTICE Notice VCCI NOTICE DOC NOTICE FCC NOTICE Notice EXCLUSION OF WARRANTY AND DISCLAIMER OF LIABILITY CABLETRON SOFTWARE PROGRAM LICENSE CABLETRON SYSTEMS, INC. PROGRAM LICENSE AGREEMENT Page BRIM-E100 Users Guide v CONTENTS Page CHAPTER 1 INTRODUCTION 1.1 USING THIS MANUAL 1.2 DOCUMENT CONVENTIONS 1.3 GETTING HELP 1.4 BRIM-E100 OVERVIEW 1.5 BRIM-E100 FEATURES Page 1.6 BRIM-E100 SPECIFICATIONS 1.7 AGENCY APPROVALS 1.8 RELATED MANUALS CHAPTER 2 CABLING REQUIREMENTS 2.1 UTP CABLE SPECIFICATIONS Page 2.2 MULTIMODE SPECIFICATIONS FOR THE FE-100FX 2.3 NETWORK CABLE LENGTHS Page CHAPTER 3 INSTALLATION 3.1 UNPACKING THE BRIM-E100 3.2 INSTALLING FAST ETHERNET INTERFACE MODULES Page Page 3.3 INSTALLING THE BRIM-E100 3.3.1 Installing a BRIM-E100 in a MIM Chapter 3: Installation Page 3-6 BRIM-E100 Users Guide Figure 3-4 Removing the BRIM Coverplate Figure 3-5 Installing the BRIM-E100 3.3.2 Installing a BRIM-E100 in a Hub Page CHAPTER 4 CONNECTING TO THE NETWORK 4.1 CONNECTING THE BRIM TO THE NETWORK 4.1.1 Connecting a UTP Segment to the BRIM-E100 Page 4.1.2 Connecting a Multimode Segment to the FE-100FX 4.1.2.1 Fiber Connection: SC Connectors Page 4.1.2.2 Fiber Connection: SC to ST Page CHAPTER 5 LOCAL MANAGEMENT Chapter 5: Local Management Page 5-2 BRIM-E100 Users Guide 5.1 LOCAL MANAGEMENT KEYBOARD CONVENTIONS 5.2 THE BRIM-E100 SETUP SCREEN 5.3 BRIM-E100 SETUP 5.3.1 FE-100TX Conguration 5.3.2 FE-100FX Conguration BRIM-E100 Users Guide Page 6-1 CHAPTER 6 LANVIEW LEDs 6.1 BRIM-E100 LEDs The BRIM-E100 has two LEDs: a Transmit (TX) and a Receive (RX). Table 6-1 describes each LED. Chapter 6: LANVIEW LEDs Page 6-2 BRIM-E100 Users Guide 6.2 FE-100TX LED The FE-100TX Fast Ethernet Interface Module has one LED. Tables 6-2 and 6-3 describe the LED. APPENDIX A FAST ETHERNET INTERFACE MODULE SPECIFICATIONS A.1 MODULE SPECIFICATIONS A.1.1 FE-100TX A.1.2 FE-100FX BRIM-E100 Users Guide Index-1 INDEX Numerics B C E