Chapter 3: Installation
Page 3-8 BRIM-E100 User’s Guide
4. Remove the hub chassis cover. Refer to your specific hub
documentation for instructions on removing the hub chassis cover.
5. Remove the faceplate mounting screws and the BRIM coverplate. See
Figure 3-4.
6. Place the BRIM-E100 behind the hub faceplate. See Figure 3-5.
7. Insert the connector pins of the BRIM-E100 into the hub connector.
8. Press down firmly on the back of the BRIM-E100 until the pins slide
all the way into the connector holes.
9. Reinstall the faceplate mounting screws, and install the standoff
screws.
10. Reattach the chassis cover to the hub, reconnect the power cord, and
reconnect the hub to your network.
11. Refer to Chapter 5 for instructions on configuring the BRIM-E100
through Local Management. Appendix A provides Fast Ethernet
Interface Module connector and pinout information.
!
CAUTION
Ensure that the standoffs on the hub align with the standoff
screw holes on the BRIM-E100.
Ensure that the chassis cover is in place before reconnecting
the power cord.
book Page 8 Friday, April 19, 1996 9:53 AM