Cabletron Systems BRIM-E100 - page 29

Chapter 4: Connecting to the Network
Page 4-4 BRIM-E100 User’s Guide
Figure 4-2 FE-100FX Port
3. At the other end of the fiber optic cable, attach the SC connector to the
other device.
4. Check that the BRIM-E100 RX LED is green or flashing yellow (refer
to Chapter 6, LANVIEW LEDs). If the LED is off, perform the
following steps until it is on:
a. Check that the power is turned on for the device at the other end of
the link.
b. Verify proper crossover of fiber strands between the applicable
port on the BRIM-E100 and the fiber optic device at the other end
of the fiber optic link segment.
c. Verify that the fiber connection meets the dB loss specifications
outlined in Chapter 2.
If a link is not established, contact Cabletron Systems Technical Support.
BRIM-E100
FE-100FX
RX
TX
166506
book Page 4 Friday, April 19, 1996 9:53 AM