INSTALLATION
2-5
The BRIM-T6 default ring speed setting is 16 Mbps. The other available
setting is 4 Mbps. To configure the ring speed, refer to the settings
illustrated in Figure 2-3 and follow these steps:
1. Remove the MIM from the MMAC; if the BRIM-T6 is installed in a
standalone device, remove the chassis cover from the device to provide
access to the BRIM-T6’s component board surface.
2. Slide the jumper down over pins 2 and 3 to select a 16 Mbps setting or
over pins 1 and 2 to select a 4 Mbps setting.
3. Reset the device containing the BRIM-T6.
Figure 2-3. BRIM-T6 Ring Speed Settings
J3
16M
SPD
4 M
16M
SPD
4 M
J3
1 2 3
16M
SPD
4 M
J3
1 2 3
Front Panel
Ring Speed Jumper Settings
4 Mbps Setting 16 Mbps Setting