Cabletron Systems manual Powering the CSX200, Installing the CSX200 in a 19-Inch Rack

Chapter 4: Installation

Installing the CSX200 in a 19-Inch Rack

Install the CSX200 in a 19-inch rack as follows:

•Position the CSX200 between the vertical frame members of the 19-inch rack.

•Fasten the CSX200 with mounting screws as shown in Figure 4-8, below.

19-Inch Rack

Screws (4)

2012_10

Figure 4-8 Installing the CSX200 in the Rack

•Complete the installation by connecting power as described in Powering the CSX200, below.

Powering the CSX200

NOTE

The CSX200 has a universal power supply. This allows you to connect the CSX200 to power sources of 100–125VAC 50/60 Hz, or 200–240 Vac, 50/60 Hz.

To connect the CSX200 to the power source, perform the following steps:

1.Plug the power cord into the back panel of the CSX200.

2.Plug the other end of the power cord into a grounded wall outlet.

3.Verify that the PWR LED is on, indicating that the CSX200 is receiving power. After the CSX200 runs a self test, the CPU LED blinks green indicating normal operation. If the LED remains red, the processor is faulty; contact Cabletron Systems (refer to Getting Help).

4-10 CSX200 Installation Guide