Cabletron Systems CSX200 10BASE-T LAN Configuration, Connecting UTP Cables to Ports 1 Through

10BASE-T LAN Configuration

10BASE-T LAN Configuration

This section contains the procedures for connecting a UTP segment from the 10BASE-T network or other devices to the CSX200. Ports 1 through 12 on the CSX200 have RJ45 connectors for UTP connections.

Connecting UTP Cables to Ports 1 Through 12

Before connecting a segment to the CSX200, check each end of the segment to verify wire crossover.

To establish a link, you must have an odd number of crossovers (preferably one)

!between 10BASE-T devices of the same type (i.e., from repeater to repeater or

transceiver to transceiver).CAUTION

Connect a twisted pair segment to the CSX200 as follows:

1.Ensure that the device at the other end of the segment is connected to the segment and is powered ON.

2.Refer to Figure 3-1. Connect the twisted pair segment to the CSX200 by inserting the RJ45 connector on the twisted pair segment into the desired RJ45 port (ports 1 through 12).

2012_11

Figure 3-1 CSX200 Twisted Pair Connection

CSX200 Installation Guide 3-3