General Configuration Using Local Management
150 CSX400 and CSX400-DC User’s Guide
Bridge_Port
X
—Use this command field to select the CSX400 bridge port you want to
configure.
Selecting a Spanning Tree Protocol
To select the Spanning Tree protocol to be used by the CSX400, perform the following steps:
1. Use the arrow keys to highlight the SPANNING TREE PROTOCOL field.
2. Press the SPACE bar or BACKSPACE to select [IEEE 802.1], [DEC], or [NONE].
3. Use the arrow keys to highlight the SAVE command field.
4. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
Selecting the Bridge Port Administrative Status
To select the bridge port administrative status, perform the following steps:
1. Use the arrow keys to highlight the [BRIDGE_PORT XX] field at the bottom of the Bridge
Setup screen.
2. Press the SPACE bar or BACKSPACE to select the bridge port you want to configure. The
selected bridge port displays in the Bridge Port Admin Status field.
3. Use the arrow keys to highlight the BRIDGE PORT ADMIN STATUS: PORT X - - > ALL
PORTS [ENABLED] field.
4. Press the SPACE bar or BACKSPACE to select ENABLE or DISABLE.
For example, the following bridge setup indicates that bridge port 01 is configured to bridge
traffic to all ports:
BRIDGE PORT ADMIN STATUS: PORT 01 - - > ALL PORTS [ENABLED]
5. Use the arrow keys to highlight the SAVE command field.
6. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.