Troubleshooting
•If you are installing the interface module and the LEDs do not come on when the base switch is powered on, verify that the interface module is properly seated in the slot.
•During diagnostics, the interface module DIAG LED is on. If the ERR LED is on at any time, it indicates that the interface module is defective and needs to be serviced.
The individual interface module ports are like the base switch ports for the purposes of troubleshooting. See the SmartStack
❏
Getting in Touch With Technical Support
For additional support related to this device or document, contact Cabletron Systems using one of the following methods:
World Wide Web | http://www.cabletron.com/ |
|
|
Phone | (603) |
|
|
Internet mail | support@cabletron.com |
|
|
FTP | ftp://ftp.cabletron.com/ |
Login | anonymous |
Password | your email address |
|
|
To send comments or suggestions concerning this document, contact the Cabletron Systems Technical Writing Department via the following email address: TechWriting@cabletron.com
Make sure to include the document Part Number in the email message.
Trademarks
SmartStack is a trademark of Cabletron Systems, Inc. All other product names are trademarks or registered trademarks of their respective holders.
Copyrights
Cabletron reserves the right to modify the information given in this publication without prior notice. The warranty terms and conditions applicable for your purchase of this equipment are given at the time of purchase. Please consult them for details.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of the publisher.
Publication: |
|
Part Number: 9032969 |
|
© February 1999 by Cabletron Systems, Inc. | CLASS 1 LASER PRODUCT |
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution
The
Token Ring
SmartStack Interface Module
for
SmartStack
Token Ring Switch
Installation Guide
4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 710001711* |