3-21
Interactive Mode
The Module Backplane Screen
Select <BACKPLANE> on the Module Specific Screen, as shown in Figure 3-24, to
access the Module Backplane Screen, as shown in Figure 3-27. The Module
Backplane Screen displays the current MMAC-Plus backplane configuration for a
selected module.
Line 1 identifies the selected module by chassis slot location.
Line 2 displays the module’s FNB connection (if applicable) and connection
status. Refer to the MMAC-Plus Operation Guide for further information about
FNB configuration.
Line 3 displays the module’s INB connection (if applicable) and connection status.
Refer to the MMAC-Plus Operation Guide for further information about the
INB.
Figure 3-27. The Module Backplane Screen
Select <EXIT> to return to the Module Specific Screen.
The Environmental Module Specific Screen
Select <EM> on the Module Selection Screen, as shown in Figure 3-23, to access
the Environmental Module Specific Screen, as shown in Figure 3-28.
Line 1 displays the Environmental Module’s current status (on-line or fault) and
the hardware revision.
Line 2 displays the Environmental Module’s firmware and boot prom revision.
Line 3 displays the Environmental Module serial number.
Figure 3-28. The Environmental Module Specific Screen
Select <ENV> to access the Environmental Module Environment Screen (used to
view Environmental Module electrical and environmental parameters).
Select <EXIT> to return the display to the Module Selection Screen.
<EXIT>
MODULE xx
INB A B/W ALLOC xxx MBPS
FDDI 1 INS PRI FDDI 2 BYP
<ENV> <EXIT>
EM STATUS ON-LINE HW REV xxx
SN xxxxxxxxxxxx
FW REV x.xx.xx BOOT PROM REV x.xx.xx