Cabletron Systems TM 9C300-1 EPIM-F1 and EPIM-F2

EPIM Speciﬁcations

A-2

EPIM-F1 and EPIM-F2

The EPIM-F1 and EPIM-F2 support Multimode Fiber Optic cabling. Each EPIM

has an internal Cabletron Systems FOT-F™ Fiber Optic Transceiver. The EPIM-F1

is equipped with SMA Connectors and the EPIM-F2 is equipped with ST

Connectors. Figure A-2 shows both EPIMs. Speciﬁcations for the EPIMs are listed

in Table A-1.

Figure A-2. EPIM-F1 and EPIM-F2

Transmitter power parameters are listed Table A-2.

Table A-1. EPIM-F1 & EPIM-F2 Speciﬁcations

Parameter Typical Value Worst

Case

Worst Case

Budget

Typical

Budget

Receive

Sensitivity -30.5 dBm -28.0 dBm — —

Peak Input

Power -7.6 dBm -8.2 dBm — —

Contents

Main Page i Notice Notice ii Notice FCC Notice DOC Notice iii Contents Chapter 3 9C300-1 Environmental Module Operation Chapter 2 Installing the 9C300-1 Environmental Module Chapter 1 Introduction Chapter 4 Specications Appendix B Uninterruptible Power Supply (UPS) Appendix A EPIM Specications Introduction The 9C300-1 Environmental Module Using This Manual MMAC Features 1-3 Related Manuals Introduction 1-4 Getting Help 2-1 Chapter 2 Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module 2-2 3-1 Chapter 3 MMAC 9C300-1 Environmental Module Operation Monitoring Functions MMAC 3-2 External Ambient Temperature Monitoring Functions Fan Speed 3-4 System Humidity Internal Operating Temperature System Voltages MMAC 3-6 Out-of-Band Management Out-of-Band Management 3-7 COM1 and COM2 Ports 3-8 The Ethernet Port Interface Module (EPIM) LCD and Keypad ENTER CABLETRON SYSTEMS, INC. MMAC-PLUS <ALARMS> <SYSTEM> <MODULES> <SCREEN CONTRAST> Non-Interactive Mode Non-Interactive Mode Screens Page Page 3-12 Interactive Mode Interactive Mode Screens Main Screen Page 3-14 CHASSIS MAC ADDRESS xx-xx-xx-xx-xx-xx <PWR> <ENV> <COM> <DIAGS> <BBU> <EXIT> CHASSIS IP ADDRESS xxx.xxx.xxx.xxx CHASSIS HW REV xxx SN xxxxxxxxxxxx Page Page Page Page 3-19 Interactive Mode FW REV x.xx.xx SMB 1 FW REV x.xx.xx <ENV> <MEMORY> <BACKPLANE> <EXIT> MODULE xx STATUS ON-LINE HW REV xxx BOOT PROM REV x.xx.xx SN xxxxxxxxxxxx Page Page Page Page Page 4-1 Chapter 4 Specications Safety ! Specications 4-2 Physical Environmental Appendix A EPIM Specications Introduction EPIM-T A-2 EPIM-F1 and EPIM-F2 A-3 EPIM-F1 and EPIM-F2 A-4 EPIM-F3 A-5 EPIM-F3 A-6 EPIM-C Connector Type Grounding A-7 EPIM-A and EPIM-X (AUI Port) EPIM-A and EPIM-X (AUI Port) Page B-1 Appendix B Uninterruptible Power Supply (UPS) Introduction Connecting a UPS to an EM Uninterruptible Power Supply (UPS) B-2 Conguring COM Port for UPS