Cabletron Systems TM 9C300-1 A-5, EPIM-F3

A-5EPIM-F3

Table A-3. EPIM-F3 Speciﬁcations

Parameter Typical Minimum Maximum

Transmitter Peak Wave

Length 1300 nm 1270 nm 1330 nm

Spectral Width 60 nm -100 nm

Rise Time 3.0 nsec 2.7 nsec 5.0 nsec

Fall Time 2.5 nsec 2.2 nsec 5.0 nsec

Duty Cycle 50.1% 49.6% 50.7%

Bit Error Rate Better than 10-10

The transmitter power levels given above are Peak Power Levels after optical

overshoot. You must use a Peak Power Meter to correctly compare the values

given above to those measured on any particular port. If you are measuring

power levels with an Average Power Meter, add 3 dBm to the average power

measurement to correctly compare the average power values measured to the

values listed above (i.e., -33.5 dBm average + 3 dB = -30.5 dBm peak).

NOTE

Contents

Main Page i Notice Notice ii Notice FCC Notice DOC Notice iii Contents Chapter 3 9C300-1 Environmental Module Operation Chapter 2 Installing the 9C300-1 Environmental Module Chapter 1 Introduction Chapter 4 Specications Appendix B Uninterruptible Power Supply (UPS) Appendix A EPIM Specications Introduction The 9C300-1 Environmental Module Using This Manual MMAC Features 1-3 Related Manuals Introduction 1-4 Getting Help 2-1 Chapter 2 Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental Module 2-2 3-1 Chapter 3 MMAC 9C300-1 Environmental Module Operation Monitoring Functions MMAC 3-2 External Ambient Temperature Monitoring Functions Fan Speed 3-4 System Humidity Internal Operating Temperature System Voltages MMAC 3-6 Out-of-Band Management Out-of-Band Management 3-7 COM1 and COM2 Ports 3-8 The Ethernet Port Interface Module (EPIM) LCD and Keypad ENTER CABLETRON SYSTEMS, INC. MMAC-PLUS <ALARMS> <SYSTEM> <MODULES> <SCREEN CONTRAST> Non-Interactive Mode Non-Interactive Mode Screens Page Page 3-12 Interactive Mode Interactive Mode Screens Main Screen Page 3-14 CHASSIS MAC ADDRESS xx-xx-xx-xx-xx-xx <PWR> <ENV> <COM> <DIAGS> <BBU> <EXIT> CHASSIS IP ADDRESS xxx.xxx.xxx.xxx CHASSIS HW REV xxx SN xxxxxxxxxxxx Page Page Page Page 3-19 Interactive Mode FW REV x.xx.xx SMB 1 FW REV x.xx.xx <ENV> <MEMORY> <BACKPLANE> <EXIT> MODULE xx STATUS ON-LINE HW REV xxx BOOT PROM REV x.xx.xx SN xxxxxxxxxxxx Page Page Page Page Page 4-1 Chapter 4 Specications Safety ! Specications 4-2 Physical Environmental Appendix A EPIM Specications Introduction EPIM-T A-2 EPIM-F1 and EPIM-F2 A-3 EPIM-F1 and EPIM-F2 A-4 EPIM-F3 A-5 EPIM-F3 A-6 EPIM-C Connector Type Grounding A-7 EPIM-A and EPIM-X (AUI Port) EPIM-A and EPIM-X (AUI Port) Page B-1 Appendix B Uninterruptible Power Supply (UPS) Introduction Connecting a UPS to an EM Uninterruptible Power Supply (UPS) B-2 Conguring COM Port for UPS