Installing and Replacing Infrared Burners
23 Appendix
1.Disconnect or shut off the liquid propane or natural gas line connect to the grill. Wait until the burners cool down.
2.Open the hood and remove the grate and flame tamer on top of the burner you want to replace.
3.Through the access door underneath the grill, find the round stud and locking pin that locks the burner you want to replace.
4.Carefully remove the locking pin with your fingers.
5.Raise the stud from the locking hole and move the burner forward carefully to release it from the ignition and gas supply valve.
6.Take the burner out of the grill and store it in a safe and dry place.
7.Install the infrared burner. Align the gas inlet on the burner with the gas supply valve on the grill and torch tube with ignition. Make sure they align perfectly. Slide the stud at the other end into the locking hole.
8.Adjust the infrared burner. Make sure the burner is aligned and in position.
9.Install the locking pin. Through the access door underneath the grill, find the stud to lock the burner in place. Install the locking pin. Make sure the locking pin is secured correctly.
10.Repeat steps 2 through 9 if you want to replace other burners.
11.Put back the grate you just removed. (You don’t need the flame tamer for infrared burners.)
12.Reconnect or turn on the gas line.
If you want to change back to regular burners, just follow the procedure above in reverse order.
Replacement Covers
Cal Flame |
|
|
BBQ010 | COVER, GRILL, SMALL, 3 BURNER | |
BBQ011 | COVER, GRILL, MEDIUM, 4 BURNER | |
BBQ012 | COVER, GRILL, LARGE, 5 BURNER | |
BBQ013 | COVER, SIDE BURNER, SINGLE & DOUBLE | |
Cal Flame Carts |
|
|
BBQ835CR4 | BARBECUE CART COVER, 4 | BURNER, BLACK |
BBQ835CR5 | BARBECUE CART COVER, 3 | & 5 BURNER, BLACK |
2009 Barbecue Grills and Carts
LTR20091038, Rev. A | www.calspas.com |
