Natural Gas
Requirements
Always check the rating plate to make sure the gas supply you are hooking up to is the gas type the grill is manufactured for.
IMPORTANT: Never connect the grill to an unregulated gas supply.
The installation of this appliance must conform with local codes or, in the absence of local codes, to the national fuel gas code, ANSI
A licensed contractor or local gas company representative must perform all natural gas connections.
Ensure that the service supplying the grill is fitted with a shut off valve conveniently positioned near the grill and giving ease of access.
The grill must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 0.5 psi (3.5 kPa).
The grill and its individual shutoff valve must be disconnected from the gas supply piping system
2009 Barbecue Grills and Carts
during any pressure testing of that system at test pressure in excess of 0.5 psi (3.5 kPa).
Your Cal Flame™ grill for use with natural gas comes equipped with its own regulator that MUST NOT be removed. If, this regulator needs to be replaced use only the type specified by Cal Flame™ for this appliance.
Connection
1.Remove the rear panel from the barbecue to gain access to the regulator and gas connection point.
2.Connect a suitable flex connector to the grill regulator.
3.Check the grill controls to ensure all control valves are in the full OFF position.
4.Turn on the main gas supply and check all connections for leaks using soapy water as described in the leak testing procedure section.
Warning: If you see bubbles in the soapy solution at any of the connections, turn off the gas supply and tighten the connection. If tightening the connection does not seal the leak, it may be necessary to replace the flex hose.
7
Installation / Assembly
LTR20091038, Rev. A | www.calspas.com |
