Caldera Paradise Series owner manual Operation Control Panel, Liquid Crystal Display LCD

OPERATION - CONTROL PANEL

Mode touch pad Selects standard	Liquid Crystal Display (LCD)	WARM (up) touch pad
or economy operating mode		Increases the temperature
LIGHT touch pad
Controls the 3-way Mood Light		COOL (down) touch pad
		Decreases the temperature
		setting
HYDRO JETS touch pads		AIR JETS touch pad
Controls Hydro Jet pumps 1 and 2		Controls the Air Jets

Geneva • Niagara • Tahitian • Hawaiian

Liquid Crystal Display (LCD)

Mode touch pad Selects standard

or economy operating mode

LIGHT touch pad

Controls the 3-way Mood Light

HYDRO JETS touch pad

Controls the Hydro Jet pump

Martinique • Kauai

WARM (up) touch pad

Increases the temperature

COOL (down) touch pad Decreases the temperature setting

AIR JETS touch pad

Controls the Air Jets

(Martinique only)

SPA-SIDE CONTROL OPERATION

Your spa-side control system consists of an illuminated Liquid Crystal Display (LCD) and convenient touch pads that allow you to set the water temperature and adjust the skim/filter cycle settings, as well as control the hydrotherapy jets, mood light and optional air jets from spa side.

LIQUID CRYSTAL DISPLAY (LCD) The LCD continually displays the current water temperature. In certain situations, other messages will appear. See page 19 for descriptions.

DISPLAY INVERSION You may invert the main, four-digit display for easier viewing from inside the

spa. Press either OR , then with- in three seconds.

Pressing the HYDRO JETS 2 touch pad turns Hydro Jets 2 the single speed pump on and off.

The pumps automatically turn off after operating for 15 minutes.

Hydro Jet pump 1 and 2 will operate automatically whenever a filter cycle is activated or when a poten- tial freezing condition is detected. If automatically activated, the pumps cannot be turned off with the Hydro Jet touch pads.

Press the AIR JETS touch pad to start or stop

AirJets the air jets. The air jets operate for 15 min-

(Option) utes, then automatically shut off.

Light The LIGHT touch pad allows you to select from

Warm

Cool

Hydro Jets 1

TEMPERATURE To display the set temperature for three seconds, press either WARM or COOL. To change the set temperature, while the set tempera- ture is displayed, press WARM to increase or COOL to decrease the set temperature.

Pressing the Hydro Jets 1 touch pad sequences the operation of the dual-speed pump as follows:

three different settings. Press the Light touch pad once to turn on the brightest setting. Press a second time to turn on the intermediate setting, and

again for the dimmest setting. Press the touch pad a fourth time to turn off the light. The light automatically turns off after 4 hours of operation.

The MODE touch pad switches between the standard and economy operating modes.

1.Low speed on.

2.High speed on.

3.Pump off (except during automatic functions).

Page 8