Manual Lighting of the Grill
·Open Hood before lighting the grill to prevent an explosion from gas
·Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced
with an assembly specified by the manufacturer prior to further use of the LP gas grill.
How to manually light your LP gas grill
1)Open Hood and Control Panel Cover.
2)Important: The LP gas cylinder valve must be opened first before turning the control knobs on the grill. Turn the LP cylinder valve counter- clockwise until it stops.
3)Using the match Wire Holder (Item 25), light a match and insert it through the
4)Locate the control knob that corresponds to the match lighting hole that you are using. Push in and turn the control knob
WARNING: If the burner fails to ignite after following the above procedure, turn all the knobs
to
the “off” position and close the valve on the LP gas cylinder. Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails to light, see the Troubleshooting page.
5) Light the remaining burners from left to right by turning the control knob
lighting another burner.
6)After ignition, burners should be burned at the “high” position for
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the “off” position and close the valve
on the LP cylinder. Open hood and wait five minutes before attempting to relight the grill. Always leave Control Panel Cover open during use to prevent excess heat buildup
and damage to your grill.
19
