Preparation Before Cooking
·Wash the porcelain coated Cooking Grids with a mixture of hot water and soap.
·Empty the foil pan and grease tray after each cook- ing session so excessive grease does not accumulate.
Failure to remove grease may result in grease dripping onto the cart and/or a grease fire in the tray.
Lighting the Grill Using the Integral
Ignition System
·Open Hood before lighting the grill to prevent an explosion from gas buildup.
·Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or shows signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose and regulator assembly must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.
How to light your LP gas grill (See diagram on next page for illustrations)
1)Open Hood and Control Panel Cover.
2)Important: Make sure control knobs are turned “off” first.
Open the LP gas cylinder valve by turning the valve counter- clockwise until it stops.
3)From the “Off” position, push control knob in on the left burner and turn
4)Light the remaining burners by turning the control knob
Confirm each burner is lit before lighting another burner.
5)If any of the burners do not light, repeat Step 3. The burner should light within three or four attempts. If burner still does not light, try the next burner from left to right.
WARNING: If any or all burners fail to light after following Steps 3 & 4, turn all knobs to the “off” position and close the valve on the LP gas cylin-
der.
Wait five minutes; then repeat all of the above lighting procedures.
Note: If the burners still fail to light, refer to the Troubleshooting page. The burner can be lit manually. See Manual Lighting of the Grill.
6)After ignition, preheat the grill by turning the control knob to “High” position for
WARNING: If a burner goes out during
the cooking cycle, turn all knobs to the “off” position and close the
The hood should be closed during preheating.
valve on the LP gas cylinder. Open hood and wait five min- utes before attempting to relight the grill. Always leave the Control Panel Cover open during use to prevent excess heat buildup and damage to your grill.
18
