PRE-INSTALLATION NOTES
Please read these notes before commencing installation.
AH10
Do not situate in close proximity to any installation which will produce excessive electrical noise such as dimmer racks etc; these may interfere with the unit.
Wiring to zones
Run a
Run two standard speaker cables from the KP10 to mounted
AUDIO INPUTS FROM SOURCES
Important!
Cambridge Audio
Enhanced
Standard
Mode Switch
See User Guide for details
AUDIO LOOP OUTPUT - CONNECT SOURCES OTHER END
Cambridge Audio Enhanced
Standard
Mode Switch
See User Guide for details
loudspeakers. If video is required, run CT100/RG6
Cabling tips
Cat5e cable should be run through the installation in electrical conduit, either metal,
Fix to a hard surface such as a cupboard surface, not to carpet or a
VH10 video hub
Locate in close proximity to the AH10 (maximum of five metres away). Fix to a hard surface such as a cupboard surface, not to carpet or a
frames or beams must be a minimum of 25mm/1inch from the nearest edge of that structure. If the frame or beam is metallic, then the cable should be protected by a bush or grommet.
When routing cables around the installation, care must be taken to prevent kinking and trapping. Any cable ties used must not be tightened any more than is necessary to hold the cable in place.
Always
16Incognito