Connections
Loudspeakers
Check the impedance of your speakers. When using a pair of speakers, you can use types with an impedance of between 4 and 8 Ohms. When using two pairs of speakers, you must use types with an impedance of 8 Ohms each, see later section.
The red coloured speaker terminals are positive (+) and the black speaker terminals are negative
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately 10mm (3/8”) or less of the outer insulation. More than 10mm could cause a short circuit. Twist the wires tightly together so there are no loose ends. Unscrew the speaker terminal, insert the speaker cable, tighten the terminal and secure the cable.
Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a CD player and a turntable and a pair of loudspeakers.
Right speaker
Black Red
Red Black Black Red
SR10
Manufactured in an | FM 75Ω | AM 300Ω | Service Port |
ISO9001 approved facility |
|
| 4– |
Ground | Right | Left |
A | A |
CD | DVD / BD Aux / MP3 Phono MM Out Rec |
Left
| B | B |
Right | Right |
|
| Right | Left |
CD | BD / DVD MP3 / Aux MM Phono Rec Out |
CD player
Left speaker
Black Red
Mains Voltage Selector Switch
115V/230V AC~50/60Hz
Power AC
Turntable
L R
8