11
Gas connection
10. Connect incoming gas supply pipe to 1
/
2” compression fitting at rear
of appliance. For inlet position see figure 13.
Log installation
11. The burner is contained within the burner chamber. Refer figure 14.
12. Carefully unpack the log set. Logs are numbered as follows:
No 1 - Left front log
No 2 - left back log
No 3 - Right front log
No 4 - Right back log
11 12
13
14
14
18. Switch the top two control buttons to “Full On” position as indicated in
figure 23(a) and using a ring spanner, as per figure 23(b), adjust the
pressure to 0.75 kPa for Natural gas or 2.65 kPa for LPG. (Turn clock-
wise to increase pressure and anticlockwise to decrease pressure).
19. Switch the heat button back to “Low Flame’ position as indicated in
figure 24(a), retain spanner in position and using a screwdriver as
per figure 24(b) adjust the central screw control to give a pressure
reading of 0.3 kPa for Natural Gas and 1.1 kPa for LPG. (Turn clock-
wise to increase pressure and anticlockwise to decrease pressure).
20. Switch burners off and remove the manometer tube. Tighten pressure
test point by turning the captive screw fully clockwise.
Replace plastic cap. Ensure the little lug is positioned towards lower
right hand side to clear the control.
21. Refit the lower front cover, making sure not to damage the power cord.
22. Follow User Instructions to turn on heater and test for correct operation
before leaving.
23.The heater flames should be stable, not lifting from burner and the logs
should glow after approximately 15 minutes operation on HIGH set-
ting.
The heater has been designed to burn with luminous flames, which
mimic natural log combustion, and may exhibit slight carbon deposi-
tion. If heavy carbon deposits occurs or flames impinge on the roof of
the combustion chamber, turn the appliance off and contact the service
agent in your state.
24.If after following these installation instructions,and the trouble shooting
chart on page 22-23, the heater does not perform correctly contact the
our Technical Services Department. For contact details please refer page
21.
23
24
Important:
To achieve the correct
visual flame effect:
On Propane the gas
pressure must be set at
2.65 kPa with burner
operating on maximum
setting.
On Natural Gas the gas
pressure must be set at
0.75kPa.