3Custom Function SettingsN

It is best to make the adjustment at the actual place where you will shoot. This will make the adjustment more precise.

With setting 2, if an Extender is used, the adjustment will be registered for the lens and Extender combination.

The registered AF microadjustments will be retained even if you use the Custom Function to clear all settings (p.204). However, the setting itself will be [0: Disable].

AF adjustment cannot be done during Live View shooting in Live and u Live modes.

C.Fn III -6 Select AF area selection mode

Make the mode selectable by selecting [Register], then pressing <0>.

Turn the <5> dial to select the mode to be used, then press <0> to append a <X> checkmark.

After making the selection, turn the <5> dial to select [Apply], then press <0>.

If you select [Enable] and press <0>, only the modes with the <X> checkmark will be selectable.

If you select [Disable] and press <0>, the default setting will make 19 point AF, Zone AF (Manual select), and Single point AF selectable.

C.Fn III -7 Manual AF point selection pattern

During manual AF point selection, the selection can either stop at the outer edge or it can go on to the opposite AF point. This is effective for all the AF area selection modes except for 19 point AF auto selection and Zone AF.

0:Stops at AF area edges

Convenient if you often use an AF point along the edge.

1:Continuous

Instead of stopping at the edge, the AF point selection continues to the opposite edge.

212