12
Chapter 2 Setup Procedures
Setting procedures and contents differ depending on the LAN installation location.
When installing, consult your system administrator to set up the LAN appropriately.
Connect the LAN cable to the LAN connection terminal of the projector.
Network configuration
Set the Wired LAN network through the projector menu. Detailed network set tings will be
made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the
settings described in this chapter before per forming steps in “3. Basic setting and opera-
tion.”
Connecting to the LAN line

Setting Procedure

1. Select “LAN mode select” in the Network menu, and press Point 8 or OK button.
2. Select similar LAN environmen t amo ng L AN1, LAN2 and LAN3 with the Point ed
buttons, and press OK but ton. Then the Menu will disappear, the “Please wait...” mes-
sage will appear, and switching o peration will start. Switching will take a while and the
projector’s LINK/ACT Lamp will be on or blink, and after completing the operation, the
“Please wait...” message will disappear.
LAN Cable
LAN Connection
Terminal
LINK Lamp (Green)
Light green when the
projector is connected to
the network correctly.
ACT Lamp (Orange)
Blink orange when the
projector is sending or
receiving the data.
* Please use a shielded LAN cable.