Installation Procedure IPNC Setup - Page 9
3. Enter the IP address for the gatekeeper followed by the # button.
The following message is displayed:
CallsSvPort=nnnn
New=_
where “nnnnn” is the value of the Management Complex (call
server/gatekeeper) transport layer port number, a value between 0 and
65535.
4. Enter the appropriate value for the port number followed by the # button.
The following message is displayed:
Router=nnn.nnn.nnn.nnn
New=_
where “nnn.nnn.nnn.nnn” is the value of the Gateway/router IP address.
5. Enter the IP address of the Gateway/router followed by the # button.
The following message is displayed:
Mask=nnn.nnn.nnn.nnn
New=_
where “nnn.nnn.nnn.nnn” is the value of the IP netmask.
6. Enter the IP netmask followed by the # button.
The following message is displayed:
FileSv=nnn.nnn.nnn.nnn
New=_
where “nnn.nnn.nnn.nnn” is the value of the TFTP server IP address.
7. Enter the IP address of the TFTP server followed by the # button.
One of the following texts is displayed left-justified at the top of the display,
depending on the current status of 802.1Q:
If 802.1Q is off: 802.1Q=off
1=on #=OK
If 802.1Q is on: 802.1Q=on
0=off #=OK
INDeX 4602 IP Telephone Installation Manual Installation Procedure - Page 9
38DHB0002UKCQ – Issue 2 (11/06/2003) IPNC Setup