Installation Procedure | IPNC Setup - Page 7 |
DHCP Phone Installation
1.Connect the longer LAN cable from the network LAN socket to the power unit's LINE socket.
Note: The 400B2 Power Adaptor used for providing power for 4602 IP Telephones is not compatible with the sockets on INDeX units. We therefore advise against the direct connection of these adaptors.
3.Connect the shorter LAN cable supplied with the IP telephone from the Power Unit's PHONE socket to the socket with a LAN port symbol () at the back of the IP telephone.
4.The phone's message indicator should glow red for a few seconds. The phone will then begin its software loading.
5.After a short delay the phone should display Initializing and then Loading…. The loading phase may take a few minutes.
•If the phone displays No Ethernet check the connection to the LAN.
6.The phone displays DHCP and a timer. After a few seconds it should complete DHCP negotiation with the Control Unit. If the timer reaches more than 60 seconds then you should suspect a error in either network or DHCP operation.
7.The phone requests the 46xxupgrade.scr file from the TFTP server (Manager). This should be visible in the Manager's TFTP Log.
8.The phone now requests additional files according to the instructions it found in the 46xxupgrade.scr file. The phone will go through a cycle of requesting files, loading files and then transferring the files into its flash memory.
9.Following file loading the phone displays Ext. =. Enter the extension number you want applied to the phone and press #.
•Wrong Set Type is displayed if you try to use the extension number of an existing
10.The phone displays Password =. Enter the password and press #.
11.The phone will briefly display the time and date and then its extension number.
12.Test that you can make and receive calls at the extension.
13.Using Manager, you can now open the Control Unit's configuration and alter the extension and user settings as required:
•In the list of extensions, the icon indicates VoIP extensions. A new extension will have been created matching the extension number entered above. In the extension's VoIP tab, the Compression Mode default is Automatic Selection. If this needs to be changed select G.729(a) 8K
•In the list of users, a new user will have been created matching the extension number entered above.
INDeX 4602 IP Telephone Installation Manual | Installation Procedure - Page 7 |
38DHB0002UKCQ – Issue 2 (11/06/2003) | IPNC Setup |
