Creating the DHCP Scope:Page 12 - Contents
Creating the DHCP Scope: The creation of DHCP Scopes should only be performed by System
Administrators with Administrator rights.
DHCP scopes are configured using the DHCP MMC snap-in as follows:
1. Start the DHCP MMC snap-in (Start/Programs/Administrative Tools/DHCP)
2. Right click on the server and select New - Scope from the context menu
3. The scope creation Wizard will be started. Click Next
4. Enter a name and description for the scope. Click Next
5. Enter the address range to use, for example from 200.200.200.1 to
200.200.200.15 (remember the host part cannot be 0). Also enter the
subnet mask as either the number of bits used or the actual mask, e.g. 24 is
the same as 255.255.255.0. Click Next
6. You can specify addresses to be excluded either by range, e.g.
200.200.200.5 to 200.200.200.7 and click Add, or just enter a Start address
and click Add, e.g. 200.200.200.12 to exclude a single address. Click Next
NOTE: You should exclude the IP Office from this range, as the DHCP
Options in the IP Office should be disabled. This is only a
recommendation. You can also accomplish this by leaving available
addresses outside of the scopes range.
Page 12 INDeX 4602 IP Telephone Installation Manual
Contents 38DHB0002UKCQ – Issue 2 (11/06/2003)