Installation Procedure IPNC Setup - Page 11
QoS Option Setting 3
Administering QoS options is not mandatory, but it is highly recommended. The
802.1Q must be switched on for the following procedure to be applicable (see
step 8 of Static Addressing Installation).
Use the following procedure to set Quality of Service (QOS) options.
1. While the phone is on-hook and idle, press the following sequence of keys
on the faceplate of the telephone:
Mute 7 6 7 # (Mute Q O S #) The following text is displayed left-justified at the top of the display:
L2 audio=d
New=_
where d is the value of the 802.1 audio quality parameter.
2. Enter a valid value (between 0 and 7).
The following text is displayed left-justified at the top of the display:
L2 signaling=d
New=_
where d is the value of the 802.1 signaling quality parameter.
3. Enter a valid value (between 0 and 7).
The following text is displayed left-justified at the top of the display:
L3 audio=dd
New=_
where dd is the value of the Differential Services audio quality parameter.
4. Enter a valid value (between 0 and 63).
The following text is displayed left-justified at the top of the display:
L3 signaling=dd
New=_
where dd is the value of the Differential Services signaling parameter.
5. Enter a valid value (between 0 and 63.
If no new values were entered during this procedure, the following text is
displayed left-justified at the top of the display:
No new values
#=OK
Press # to terminate the procedure.
If new values were entered during this procedure, the following text is
displayed left-justified at the top of the display:
Save new values
*=OK #=yes
Press the * button to terminate the procedure, or the # button to save the
new values. If you press the # button, the following text is displayed:
New values?
Being saved
The new values are saved, and the user interface is restored to its previous
state.
INDeX 4602 IP Telephone Installation Manual Installation Procedure - Page 11
38DHB0002UKCQ – Issue 2 (11/06/2003) IPNC Setup