Setting

To Change the PIN code lock setting

Select Off, On1, or On2 with the Point 7 8 button and then "Quit" with the Point d button and press the SET button to close the dialog box.

To Change the PIN code

The PIN code can be changed to your desired four-digit number.

Select "PIN code change" with the Point d button, and press the SET button. The New PIN code input dialog box will appear.

Select a number with the Point 7 8 button and fix the number with the SET button. Repeat it to complete entering a four-digit number. When the four-digit number is fixed, the pointer will automatically move to "Set". Then press the SET button.

Be sure to note the new Logo PIN code and keep it at hand.

✔Note:

If you forget your PIN code and unable to start operating the projector, the PIN code can be reset to the factory default setting (1234) according to the following procedure When you reset the PIN code, the Logo PIN code will be reset, as well.

1.Disconnect the AC Power Cord from the AC outlet.

2.As pressing the SET button on the projector, connect the AC Power Cord into an AC outlet again. Keep pressing the SET button until the POWER indicator lights. The PIN code will be returned to the factory default setting while the PIN code lock state will remain the same as previous set state.

Change the PIN code lock setting

Select a desired setting with the Point 78 button.

Change the PIN code

Select PIN code change and press the SET button. The New PIN code input dialog box will appear.

The input numbers are being displayed for confirmation.

Fan

This function provides you the following alternatives in the cooling fans operation after turning off the projector.

L1 . . . . . . . .normal operation. Cooling the projector for 90 seconds after turning off the projector.

L2 . . . . . .slower operation than the normal (L1) , but takes longer to cool down the projector. Cooling the projector for 120 seconds after turning off the projector.

Lamp counter reset

This function is used to reset the lamp replace counter. When replacing the projection lamp, reset the lamp replace counter by using this function. See page 51 for operation.

Factory default

This function returns all setting values except for the PIN code lock, the Logo PIN code lock, the User logo and the lamp counter to the factory default settings.

Fan

Factory default

Select Factory default and this box appears. Select [Yes] , and the next box appears.

Select [Yes] to activate it.

46