Connect the AC power cord to the projector and turn on the projector.
Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes.
Loosen the screw with a screwdriver, and remove the lamp cover.
Loosen 2 screws of the lamp with a screwdriver and pull out the lamp by grasping the handle.

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an

end, the LAMP REPLACE indicator lights yellow. If this indicatorTop Control lights yellow, replace the lamp with a new one promptly.

This indicator lights yellow

KEY

STONE

when the life of the projection

VOL

+

lamp draws to an end.

LAMP REPLACE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CAUTION

 

 

 

CAUTION

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Allow a projector to cool, for at least 45 minutes before

For continued safety, replace with a lamp of the same

 

you open the Lamp cover. The inside of the projector

 

type. Do not drop a lamp or touch a glass bulb! The

 

 

can become very hot.

 

glass can shatter and may cause injury.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Follow these steps to replace the lamp.

1

2

3

4 Replace the lamp with a new one and tighten the 2 screws back into position. Make sure that the lamp is set properly. Replace the lamp cover and tighten the screw.

5

6 Reset the Lamp replace counter.

See “Lamp Replace Counter” on the next page .

Lamp Cover

Screw

Screw

Lamp

Screw

Handle

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●

Model No. of your projector

:

LV-X4, LV-7230

●

Replacement Lamp Type No.

:

LV-LP21 (for LV-X4)

 

 

 

(610 315 5647)

 

 

 

LV-LP18 (for LV-7230)

 

 

 

(610 309 2706)

50