Part Names and Functions

Terminal

qw e r t y

RGB IN-1/

AUDIO

COMPONENT IN

R IN

 

*

SERVICE PORT

 

RESET

 

RGB IN-2/

 

RGB OUT

qRGB IN-1/ COMPONENT IN

Connect output signal from a computer (Analog RGB) or video equipment (Component or RGB Scart) to this terminal. Optional cables are required when using this terminal as component input or RGB Scart 21-Pin Video input. (p17.19)

wSERVICE PORT

This jack is used to service this projector.

eAUDIO IN

Connect the audio output from video equipment connected to r or i to this jack. (When the audio output is monaural, connect it to L (MONO) jack.) (p18)

L

VIDEO IN

 

S-VIDEO IN COMPUTER

 

AUDIO IN

 

AUDIO OUT

ui o

yCOMPUTER AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to q or u to this jack. (p17,19)

uRGB IN-2 / RGB OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. (Used for Monitor out, this terminal outputs only incoming signal from RGB IN-1/ COMPONENT IN terminal.) (p17,43)

iS-VIDEO IN

Connect the S-VIDEO IN output from video equipment to this jack. (p18)

r VIDEO IN

o AUDIO OUT

Connect the composite video output from video

equipment to VIDEO jack. (p18)

Connect an external audio amplifier to this jack. (p17,

 

 

18,19)

t USB (Series B)

This terminal outputs sound from AUDIO IN terminal (e

When operating the connected computer with the

or y).

remote control unit, connect USB port of your computer

 

to this connector with a USB cable. (p17)

 

✽A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET

button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

9