Canon MD205, MD216, MD215, MD235 instruction manual Playback, List of Messages in alphabetical order

Playback

During playback there is video noise.

- Video heads are dirty. Clean the video heads ( 2).

Playback does not start.

-Load a cassette ( 25).

-Set the camcorder to ( 31).

-Tape reached the end (“ END” appears on the screen). Rewind the tape ( 25).

No sound from the built-in speaker.

-Open the LCD panel.

-Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting ( 32).

Image will not appear on the TV screen.

- Check again that the camcorder is properly connected to the TV ( 47).

Tape is running, but image will not appear on the TV screen.

-TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO ( 48).

-Video heads are dirty. Clean the video heads ( 2).

-You attempted to play back or dub a copyright protected tape. Stop playback/dubbing.

List of Messages (in alphabetical order)

CHANGE THE BATTERY PACK
-	Battery pack is exhausted. Replace or charge the battery pack (				15).
	CHECK THE CASSETTE	[AUDIO MODE]
-	You attempted to dub audio (	49) on a tape recorded with an audio mode other than [				12bit].
	CHECK THE CASSETTE	[BLANK]
-	You attempted to dub audio (	49) on a tape with a blank section.
	CHECK THE CASSETTE	[INCORRECT TAPE SPECIFICATION]
-	You attempted to dub audio (	49) on a tape recorded in HD (high definition) standard.
	CHECK THE CASSETTE	[REC MODE]
-	You attempted to dub audio (	49) on a tape recorded in a recording mode other than SP.
CONDENSATION HAS BEEN DETECTED
-	Condensation has been detected in the camcorder (			66).
CONDENSATION HAS BEEN DETECTED REMOVE THE CASSETTE
-	Condensation has been detected in the camcorder (			66). Remove the cassette.
HEADS DIRTY, USE CLEANING CASSETTE
-	Video heads are dirty. Clean the video heads (		2).

61