Canon X-Loupe manual Assembling

Assembling

As picture shown on the left, tuck Canon digital camera into X-Loupe module.

Make sure that the left and bottom edges of the Canon digital camera are in close contact with X-Loupe module.

Make sure that the screw hole on the bottom of the module is aligned with the tripod socket of the camera. Insert the screw into the hole.

Rotate a coin clockwise to tightly lock the screw. Please make sure that both Canon digital camera and the module are well locked.

To disassemble X-Loupe module from Canon digital camera, rotate a coin counterclock- wise. Pay attention to both camera and module to prevent them from falling . Please store the screw in a proper place, It is advised to put it back into the carrying case.

Assembling

Hold the camera and module in one hand and take the objective lens with the other hand. Align the red dot on the objective lens with the other red dot on the module.

Attach the objective lens to the module.

Rotate the objective lens clockwise until the sound,｀ka´, is heard. Do not over-rotate the objective lens.

For the safety purpose, please make sure that the objective lens is not loose.

To change the objective lens, press the release button and rotate the objective lens counterclockwise for 45 degrees. Easily and softly disas- semble the objective lens from the module. Do not over-rotate the

objective lens. Repeat above procedures to assemble another objective lens onto the module.

page38 page39