27
Models QS12 & QS24 Operating Procedures
IMPORTANT: Do not use a jet of water to
clean or rinse thegrill.
Step 12
Use the rubber wiper squeegee to remove excess
liquid from the upper and lower surfaces.
IMPORTANT! Do not scrape the upper surface
withmetal utensils. It is aluminumand will scratch
very easily.
Step 13
RepeatSt eps 10and 11 if necessary, but apply cleaner
only to soiled areas.
Step 14
Remove any small carbon spots with the rubber
squeegee.
Step 15
Using a damp cloth, wipe down all exterior stainless
steel of the upper cook surf ace (especially behind the
rear of the upper cook surface, next to arm assembly).
Note: Grills should be removed from c ooking alcoves
in order to clean the rear section of the upper cook
surface.
Step 16
Clean lower grill by pouring warm water carefully on
the surface while brushing with sturdy brush.
CAUTION: Wear rubbergloves to avoid
hot steam.
Step 17
Continue to add water and brush the surface until t he
grill is cool enough to squeegee dry.
Step 18
Wipe the cook surface(s) twice with a clean, damp
towel.
Step 19
Wipe all areas of the grill with a clean, damp towel.
Step 20
Wipe all exterior stainless steel panels around the
entire grill.
CAUTION:
SNever use cold water or ice to cool the
upper cook surface or lower grill plate.
SNever use grill screens on the upper cook
surface or lower grill plate.
SNever use any other abrasives or cleaners
other than approved food service cleaners
and degreasers.
SNever spray excessive amounts of water on
the grill.
SNever pour or spray liquid of any type on
the top of the upper cook surface.
Step 21
Place release material sheet(s) on the warm lowergrill
plate and thoroughly wipe down both sides with a
clean, damp grill cloth.
CAUTION:
SNever attempt to clean release material
sheets on a cold surface.
SNever use a hot hose for cleaning release
material, or soak release material sheets in
liquid.
SNever fold, crease or touch release material
sheets with sharp objects.
SNever allow the grill scraper or abrasive
cleaning materials to come in contact with
release material sheets.
Step 22
Apply a light coat of shortening to the ent ire lower grill
plate.