4
To the Installer Models QS12 & QS24
090401
Step 8
Lower the upper cook surface into the COOK position.
Figure 9
Step 9
Wearing proper protection, attempt to rock the cook
surface assembly. Apply pressure on the locating pins
at opposite corners to each other as shown in F igure
10.
Figure 10
Step 10
If the unit rocks, split the adjustment for gap pins
across the uneven corners, as shown in Figure 11.
Figure 11
Step 11
After adjusting, verify the unit for stability.
Step 12
If all adjustments on t he cook surface are correct, and
no rocking occurs, tighten the two screws located on
the side of the front and rear gap slides to lock all
adjustments from moving.
It is highly recommended that the gap
slides and the gap slide ret ainers be
removed at least weekly for cleaning th ese
partsand the cook surface shroudbehind
these parts.
These parts are easily removed by
removing the locating pins and holding
both parts, because they are n ot attached
together,and pulling them from the cook
surface.
Take the gap slides to the sink for
cleaning. (Be sure to re-install the g ap
slides as they were removed, i.e., “F ”
front.) See Weekly Cleaning Procedures
on page 28.