Table 2 Ð Overall Dimensions, 16DF013-025
English
UNIT |
|
| OVERALL DIMENSIONS |
|
| |||||||
16DF | 013 | 015 | 018 | 020 | 023 | 025 | ||||||
LENGTH | ||||||||||||
WIDTH | 6- | 7 | 6- | 7 | 7- | 8 | 7- | 8 | 8- | 3 | 8- | 3 |
HEIGHT | 7- | 9 | 7- | 9 | 7- | 9 | 7- | 9 | 8- | 3 | 8- | 3 |
|
|
|
|
| SI |
|
|
|
|
|
|
|
UNIT |
|
| OVERALL DIMENSIONS (mm) |
|
| |||||||
16DF | 013 | 015 | 018 | 020 | 023 | 025 | ||||||
LENGTH | 3600 | 3600 | 3600 | 3600 | 3600 | 3600 | ||||||
WIDTH | 1995 | 1995 | 2330 | 2330 | 2520 | 2520 | ||||||
HEIGHT | 2350 | 2350 | 2350 | 2350 | 2500 | 2500 |
Table 3 Ð Overall Dimensions, 16DF028-050
English
UNIT |
| OVERALL DIMENSIONS |
| |||
16DF | 028 | 032 | 036 | 040 | 045 | 050 |
LENGTH | 15- 4 | 15- 4 | ||||
WIDTH | ||||||
HEIGHT | ||||||
|
|
| SI |
|
|
|
UNIT |
| OVERALL DIMENSIONS (mm) |
| |||
16DF | 028 | 032 | 036 | 040 | 045 | 050 |
LENGTH | 4660 | 4660 | 4660 | 4660 | 4660 | 4660 |
WIDTH | 2850 | 2850 | 3000 | 3000 | 3200 | 3200 |
HEIGHT | 2595 | 2595 | 2695 | 2695 | 2950 | 2950 |
RIGGING Ð The 2 pieces are the
1.Lift each assembly with cable, hooks, and shackles con- nected to the 4 lifting holes on each assembly. Lifting from other holes or locations can damage the machine.
2.Position and level the
3.Move the
4.Align connecting piping for
5.See Mounting the Burner section for burner rigging instructions.
Position and Level the Equipment Ð Isolation pads are not necessary for most installations. However, for cases where isolation pads are required, refer to Fig. 7 for typical installation.
Both 16DF machine assemblies must be level within 1¤4 in. per 20 ft (6.3 mm per 6 m), both lengthwise and di- agonally. To level the machine, proceed as follows:
1.Completely ®ll
2.Use water gage and leveling reference points stamped on tube sheets to level machine.
3.Level machine with shims until requirements are met. If isolation assembly is used, shim under the soleplate. Be sure matching piping is in alignment.
Fig. 6 Ð Rigging 2-Piece Units, Sizes 16DF023-050
NOTES:
1.Be sure only the machine base is on the isolation pad at each corner.
2.Shim under soleplate to level machine.
Fig. 7 Ð Typical Isolation Assembly
6