SET SCREW | SET SCREW | MOUNTING HUB |
| ||
3/16" |
|
|
GAP |
|
|
MOUNTING HUB |
|
|
ACTUATOR
HOUSING
DAMPER |
| PLASTIC COVER |
| |
|
| QUICK BLADE |
| |
|
| RELEASE |
| |
|
| CLS | COM OPN | |
|
| CLS | COM | |
|
|
| OPN | |
3/16" |
| (CLS) CLOSED |
| |
| (COM) COMMON |
| ||
GAP | ||||
(OPN) OPEN | ||||
| MOUNTING SCREW | MOUNTING SCREW (5/16") | ||
|
|
Fig. 1 — Damper 24-vac Connections
C03024
1/2 ″ STEEL STRAP
Fig. 2 — Insulated Round Metal Duct Work
A95130
SUPPLY
AIR DUCT
DRIVE ZONE
DAMPER
Fig. 3 — Rectangular Metal Duct Work
A92478
1 1/2 " TO 2"
INSULATION
Fig. 4 — Insulated Rectangular Metal Duct Work
A95131
Step 5—FINAL WIRING
Bring all damper and sensor wires together at the Infinity Damper Control. Make all system wiring connections as indicated in Fig. 9. The two ABCD bus connections on the Infinity Damper Control
FLEXIBLE | ZONE |
DUCT | DAMPER |
Fig. 5 — Round Flexible Duct Work
A95132
1/2 ″ STEEL STRAP
Fig. 6 — Insulated Round Flexible Duct Work
| A95133 | |
FIBROUS | FIELD | |
GLASS | ||
SUPPLIED | ||
DUCTWORK | ||
SCREWS | ||
| ||
| ZONE | |
| DAMPER |
2″ TO 3″
Fig. 7 — Rectangular Fibrous Glass Duct Work
A92480
1 1/2 ″ TO 2″
INSULATION
Fig. 8 — Insulated Rectangular Fibrous Glass Duct
Work
A95134
are in parallel with each other. Use either terminal block to connect the Zoning User Interface, Smart Sensor(s),
VENTILATOR WIRING — The Infinity Damper Control can control a Carrier Heat Recovery Ventilator or Energy Recovery Ventilator (HRV / ERV). Connect the four wires from the ventilator control board (see ventilator installation instructions for details) to the connector labeled (YRGB). This label identifies the color of the wire to match the ventilator wire colors (Y=yellow, R=red, G=green, B=blue or black). If you have two Infinity Damper Controls, connect the ventilator to the control for zones 1 through 4.
LEAVING AIR TEMPERATURE / HEAT PUMP TEM- PERATURE (LAT/HPT) SENSORS — These inputs on the
Infinity Damper Control are used only for diagnostic purposes and
4