Manuals / Carrier Access / Computer Equipment / Computer Hardware

Carrier Access 600, EdgeFLEX installation manual Electrostatic Discharge ESD Precautions

Models: 600 EdgeFLEX

1 54

Download 54 pages 436 b

Page 10

Preface

Electrostatic Discharge (ESD) Precautions

Electrostatic Discharge (ESD) Precautions

ESD can damage processors, circuit cards, and other electronic components. Always observe the following precautions before installing a system component.

1.Do not remove a component from its protective packaging until ready to install.

2.Wear a wrist grounding strap and attach it to a metal part of the system unit before handling components. If a wrist strap is not available, maintain contact with the system unit throughout any procedure requiring ESD protection.

WARNING! INTEGRATED CIRCUITS (ICS) ARE EXTREMELY SUSCEPTIBLE TO ELECTROSTATIC DISCHARGE. UNLESS YOU ARE A QUALIFIED SERVICE TECHNICIAN WHO USES TOOLS AND TECHNIQUES THAT CONFORM TO ACCEPTED INDUSTRY PRACTICES, DO NOT HANDLE ICS.

The ESD warning label appears on packages and storage bags that contain static-sensitive products and components.

x	EdgeFLEX 600 - Release 2.0

Image 10

Carrier Access 600, EdgeFLEX installation manual Electrostatic Discharge ESD Precautions

Contents

EdgeFLEX Page FCC Requirements, Part Safety of Information Technology EquipmentCompliance Industry Canada ICES-003Europe EN55022 and AS/NZS CISPR22 Nebs Level 3 Requirements Compliance EdgeFLEX 600 Release Safety Notices Class 1 Laser Product Safety WarningDC Power Supply Warnings AC Power Supply Service and Maintenance End UserDC Power Supply Safety Information Electrostatic Discharge ESD Precautions Warranty Limitation of Warranty & Limitation of RemediesWarranty Product Returns Table of Contents Adding and Replacing Components Connector Pin AssignmentsIndex Chapter Hardware Overview EdgeFLEX 600 Front ViewTechnical Specifications Site PlanningCompliance Specifications Environmental SpecificationsRelated Documentation EdgeFLEX 600 Installation Checking the Contents Preparing for InstallationRequired Tools to Unpack and Install the Chassis Unpacking the EdgeFLEXChassis Components Fan Tray, System Interfaces, and Power Supply UnitsPower Supply Unit LED Locations Front Panel LEDs and System Interfaces LocationsInstalling the EdgeFLEX 600 Chassis in a Rack Installing Flanges on the ChassisEdgeFLEX 600 Installation Rack Installation Connecting Power Installing the Decorative BezelRequirements for DC Power Connections Connecting Chassis to Ground Wiring and Connecting DC Power Connecting the Management Cables Connecting System CablesSystem Management Connectors System Management ConnectionsConnecting the Timing Output Cable Connecting the Local Console CableConnecting the Timing Input Cable Connecting the Alarm ContactsConnecting Network Cables Selecting the Appropriate Network CablesConnecting to 10/100 Ethernet Interfaces Connecting to DS1/E1 InterfacesConnecting to Optical Interfaces Powering Up the Chassis Powering Up and Checking LEDsCard LED Locations Checking System Status LEDs Check Management Port Ethernet LEDsCard Type LED Label Description Normal State Alarm State Check I/O Card LEDsRouting Cables Routing System and Network CablesAdding and Replacing Components Replacing the Air Filter Replacing a Fan Tray Adding and Replacing Components Replacing an SFP Module Removing/Installing Cards Operating the Ejector Latches Card Removal/InsertionAdding and Replacing Components Nonreplaceable Components Nonreplaceable Components EdgeFLEX 600 Release Appendix a Pin Locations Ethernet RJ-45 Pinout management portTiming Port Pinout Serial Port PinoutTiming In Ports Alarm Inputs Pinout Timing Out PortsAlarm Outputs Pinout Alarm Outputs Pinout EdgeFLEX 600 Release Index Index