Carrier Access 600, EdgeFLEX installation manual Routing Cables, Routing System and Network Cables

EdgeFLEX 600 Installation

Routing Cables

Routing Cables

Routing System and Network Cables

The EdgeFLEX 600 accessory kit includes a cable management bracket that you can use to position the system and network cables around the chassis.

If you installed the optional cable management bracket (see Rack Installation, on page 2-6), use the following guidelines to route the cables:

Route the power cables from the PSU units to the left side and secure using a tie-wrap.

Route all management cables through the cable management bracket on the left front of the chassis and secure them using a tie-wrap.

Route all network cables through the cable management bracket and secure them using a tie- wrap.

CAUTION! FIBER-OPTIC CABLES ARE DELICATE AND CARE MUST BE EXERCISED WHEN DRESSING CABLES TO AVOID DAMAGE TO THE CABLE. BE SURE NOT TO BEND THE CABLES TOO TIGHTLY; FIBER OPTIC CABLES TYPICALLY HAVE A MINIMUM BEND RADIUS OF 1.2 INCHES (30.5 MM) WHICH MUST BE OBSERVED. REFER TO THE MANUFACTURER’S SPECIFICATIONS FOR THE SPECIFIC CABLES BEING INSTALLED.

2-18 EdgeFLEX 600 - Release 2.0