Carrier Access KTA Configuration, Configuring Network Parameters from Telephone Handset

(3)Plug one side of the RJ-11 of phone line to the PHONE Port(FXS) ⑤of KTA, plug another side of the phone line into user terminal (phone, line entrance to PABX, etc.).

(4)If you are the KTA1010,KTA1011’s user, put the phone line to the LINE Port(FXO) ⑥of KTA, you will have the both function of VoIP and PSTN.

(5)Plug the accessory power-adapter into the power outlet, then connect the output-plug to power-port ① of the KTA.

(6)Then waiting for KTA’s startup, after hearing short phone ring, KTA is now working.

Notice: Please select different type of Ethernet Cable according to the network devices (devices connecting to LAN). Select Straight-through Ethernet Cable for network equipments (router, hub, etc.); Select Cross-over Ethernet Cable for the PC of ISP server; Select the corresponding Ethernet Cable according to the instructions of XDSL and Cable Modem (using Straight-through Ethernet Cable in most casts).

3.2 Configuration

3.2.1 Configuring Network Parameters from Telephone Handset

Without PC,users and network technician can set parameter through ordinary phone and KTA,all those operations can be finished under VoIP model.

Instrucitons for network parameter setting:

Command Format:

Every configuration command from your telephone handset will be similar to the following format: #*xxxxx#.Commands are a minimum of 3 digits. If a command is prefixed by ”#*” then the command is a query. If the command is prefixed by just ”#” then it is a programming command. Use ”##” to cancel a command.

If the command is successful you will hear “di du”. If the command is unsuccessful you will hear ”du du du…”

Common commands:

Note: Each Command below is followed by its alphanumeric representation to make it easy to remember.

Query IP Address: pick-up phone handset and key in #*047# or #*0IP#

Set IP address: pick-up handset and key in #73847# xxx*xxx*xxx*xxx# or #SETIP#xxx.xxx.xxx.xxx#

Enable DHCP: pick-up handset,then key in #3427# or #DHCP#

Disable DHCP: pick-up handset, then key in ##3427# or ##DHCP#

Reboot: pick-up handest,then key in #778# or #RST#

Restore default settings: pick-up handset ,then key in #358# or #DLT# Using H.323:pick-up handset ,then key in #4323# or #H323#

Using SIP:pick-up handset ,then key in #747# or #SIP#

Using adjusting IP:pick-up handset,then key in #3228# or #FACT#.IP type is STATIC IP.IP address:192.168.1.100,Gateway IP:192.168.1.1,Subnet mask:255.255.255.0.

Note: After performing each of the above commands the KTA will reboot. You should wait until your telephone rings once to indicate that the reboot process has been completed.

Notice:DHCP is a default setting of KTA Series.

3.2.2 Configuring Network Parameters from Web Browser

Open your web browser and enter the IP Address that has been assigned to the KTA (if necessary use the “Query IP Address” command in the above section). Log-in page will be displayed. The default password is 1234.

Browser, such as Microsoft Internet Explorer of Windows operating system, to set up parameters.

5