®3
|
| Operation Power |
|
|
|
|
|
|
The | button is normally left in the on position. Always turn the power off |
during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs.
The | button must be left on to retain a previously set fan speed or light level. |
Operation Speed Control
There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.
To select the desired fan speed:
1.With fan off, press and hold the button labeled . The fan blades will start rotating at the slowest speed, and will increase in steps.
2.Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the
same speed each time the | button is used. To maintain this level | |
of speed, turn the fan on by pressing | less than one second. To |
lower speed, turn fan off, then on by pressing and holding the button until the desired speed is reached. When the fan is on, you may
increase the speed by pressing and holding the | button until the |
desired speed is reached, then release it. |
|
Fan Control
ON - OFF:
Amomentary press of the FAN button
Change speed:
Press and hold
FAN button longer than one second
Operation Reversing Airflow
The direction of airflow can be changed from down- ward to upward or from upward to downward.
To reverse the airflow: |
|
1. Make sure the | is on and blades are Turn- |
ing. |
|
2. Press the | button. |
Note: A
Operation lights
To turn the lights off and on, press and release the | button for less than |
one second. |
|
1) First press/release of the button- The light will turn ON.
2) Second press/release of the button- The light will turn OFF. To vary the light brightness at each touch level:
To vary the light brightness:
1.With lights off, press and hold the button. After one second the lights will come on at their lowest level and gradually become brighter.
NOTE: Light Operation - the light varies from “bright” to “dim” over approximately 8 seconds. This sequence will reverse the light when it reaches the brightest or dimmest level if you continue to hold the LIGHT button. Release the button when the desired level is reached.
2. Release the button when the desired brightness level is reached.
The brightness level is now in the fan memory and will automatically come on at the same brightness the next time the button is used.
Light Control
ON - OFF:
A momentary press of
the LIGHT button
Change bright-
ness:
Press and hold
LIGHT button
longer than one
second
12