attaching the blades
Step 3a. Attach the 5 blade tips to the blades using two 6‑32x1⁄8” round head screws provided. Note: the screws have locktite on them, so once they are installed it will be difficult to remove the screws.
Step 3b. Attach each of the five blades to the blade holders using four of the truss head screws and fiber washers provided for each blade. The truss head screw
is placed through the blade and then a fiber washer is pressed on so that it is between the blade and blade holder; see the detail drawing below. Hand tighten each truss head screw firmly.
3a - BLADE TIP installation:
6‑32x1⁄8”
round head BLADE screw
6‑32x1⁄8”
BLADE round head screw
BLADE TIP BLADE TIP
3b - BLADE installation:
BLADE |
| TRUSS HEAD |
HOLDER | BLADE | BLADEHOLDER |
BLADE |
| SCREW |
|
|
BLADE |
TIP |
FIBER
BLADE- WASHER HOLDER
hanging fan body in canopy
Step 4. To hang the fan body in the canopy, support the fan at the center of the glass holder and top support and insert the ball into the canopy opening. Rotate the fan body until the slot in the ball fits into the pin opposite the
canopy opening.
Note: Write down the
TOP SUPPORTSerial Number and the model number for future reference.
GLASS
ball
pin slot
HOLDERNote: Fan Weight is 33 lbs.
INSIDE
canopy electrical connectors
Step 5. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and securing with a wire nut. Connect in this order:
•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.
•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.
•BLACK wire from fan to black (or red) POWER wire in ceiling fixture outlet box. Secure with wire nut.
BLACK WIRES
(2)
WHITE WIRES
(2)
GREEN WIRES
(3)
wire nut
6