Casablanca Fan Company 3243Z Changing Frequency Setting, Automatic Demonstration Program, + +++

®3

Changing Frequency Setting

NOTE: All fans leave the factory set to

“1111”

DIP

SWITCHES

You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.

Step 1. Turn power OFF at the circuit breaker or fuse box and at the toggle switch, for the fan you want to change.

NOTE: DO NOT set dip switch setting in the remote to ‘0000’, this may cause frequency interference from other Casablanca Products.

Step 2. Remove the screws and switch plate from the existing switch box.

Step 3. Remove the screws holding the switch in the switch box.

Step 4. Pull the existing W-85 switch from the switch box to expose the dip switches located on the side of the control as shown in Figure #1.

Step 5. Change the dip switch settings, assuring that they are different from the previously installed Inteli-Touch®3 fan.

Step 6. Mount the W-85 Wall Control unit back into the wall electrical box.

Step 7. At the circuit breaker or fuse box and at the toggle switch, turn the power off for the fan whose frequency you are changing.

Step 8. Within 20 seconds of restoring power to the ceiling fan and the W-85 Wall Control press and hold both the “FAN” and “REVERSE” buttons as shown in Figure #2 for 3 seconds, you will hear one tone from the Piezo Buzzer indicating the com- mand has been accepted.

DIP SWITCHES	DIP SWITCHES
SET TO ‘1111’	SET TO ‘1001’
(Factory Setting)

Automatic Demonstration Program

Programmed into every Inteli-Touch®3 Series fan is an Automatic Demonstration Program. It can be used to fully demonstrate and test the operation of the fan.

To enter the demonstration program:

1.Turn off for at least 5 seconds. This will clear the fan memory ready for programming.

2. Turn on.

3.Immediately operate the buttons in the following sequence:

+ +++

A multi-tone signal will verify the start of the test pro- gram which proceeds as follows:

•Lights slowly increase to full intensity.

•Fan accelerates to speed three with audio tones.

•Light dims to half intensity.

•Fan accelerates to full speed with audio tones.

•Fan reverses at full speed with audio tones.

•Fan operates at full speed.

•Fan turns off with audio tones (blades coast for a short time).

•Lights turn off.

The complete cycle lasts slightly over one minute. It

will continue to repeat until the is turned off for more than five seconds, cancelling the program.

13