Stealth®
canopy hatch INSTALLATION
Step 6. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the white and black wires are on opposite sides of the canopy and all wires are clear of the canopy opening.
Step 7. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening.
Tip: Place the lock washer on the canopy screw, and the screw through the hatch before tilting the fan to install the hatch onto the canopy.
Step 8. Straighten the fan, then check to ensure that there is no movement between the canopy and ceiling or
hatch
canopy
lock washer canopy
screw
canopy
tilt the fan to install last
canopy screw
bulb INSTALLATION
Step 9.Screw the
Do not touch the glass bulb with your
or dirty, clean carefully with a tissue. A dirty glass bulb will cause the bulb to fail almost immediately.
IMPORTANT! When installing the halogen bulb, carefully cut off the end of the plastic sleeve the bulb comes in and hold the bulb by the plastic sleeve to screw it into the socket.
NOTE: In compliance with US Federal Energy Regulations, this ceiling fan contains a device that restricts the light kit to a maximum of 190 watts. Exceeding that limit or the marked limit on this product may result in a fire hazard or improper operation.
halogen bulb | tabs |
100 WATT Max. |
installing the glass
Step 10. Position the indentations in the outer rim of the glass so that they line up with the tabs on the inside sur- face of the fan light fixture rim.
Step 11. Carefully lift the glass shade up inside the light fixture as far as it will go.
Step 12. Rotate the glass shade in a clockwise direction until it falls into the notch for each tab.
Step 13. Turn power back ON at the circuit breaker or fusebox.
This completes the installation of the fan.
MODEL AND SERIAL num- ber PLATE
NOTCH | Indentation | |
for tab | ||
for tab | ||
| ||
GLASS |
|
7