Stealth® 
STEALTH INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
perma•lock™ hardware
ALLEN SET SCREW |
| downrod & Ball |
1/8” | assembly | |
| ||
allen wrench |
| |
|
|
Fan preparation
| important safety information! |
| motor | |
| before starting the installation ofyour ceiling fan, in- | |||
| stall the threaded downrod into the motor coupling and | wires | ||
| lock the assembly |
|
| |
|
|
|
| |
Prepare for fan installation as follows: |
|
| ||
Step A. Route the wires from the motor through the |
|
| ||
Perma•Lock™ downrod and ball assembly. |
|
| ||
| Tip: The downrod has a tapered |
|
| |
| thread that is designed to lock com- |
|
| |
| pletely when correctly installed. | tapered | ||
Step B. Using the provided allen wrench, loosen the set | ||||
thread | ||||
screw several turns to allow installation of the downrod. |
|
| ||
Thread the downrod into the motor coupling until it stops |
|
| ||
turning, this will take at least four and a half full turns. | ALLEN |
| ||
SET SCREW
Step C. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!
ground
wire
downrod
&Ball assembly
motor
coupling
3
