WAILEATM
CEILING HARDWARE
CROSSBAR | WIRE NUT (4) |
MOUNTING |
|
BRACKET |
|
ADDITIONAL HARDWARE
21/4″ x
HEAD SCREW (2)
1″ x | FLAT WASHER (2) | |
HEAD SCREW (2) | ||
|
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning:Toreducetheriskoffire,electricalshock, or personal injury, mount to outlet box marked acceptableforceilingfansupportusingthemount- inghardwareprovidedwiththeoutletbox.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is marked ‘Approved for ceiling fan mounting’. If it is not, a new
box must be installed.
CROSSBAR MOUNTING BRACKET INSTALLATION
WARNING: Damp Location rated fans require a Ground Fault Interrupter (GFI). Use a
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through the crossbar mounting bracket center hole. Attach the bracket, with ground wire and ridges down, to the ceiling fixture out- let box with the mounting hardware included with the outlet box.
Using the screwdriver, tighten the screws firmly by hand only, being careful not to bend the bracket by over tightening.
CAUTION: To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.
CEILING FAN
APPROVED
OUTLET BOX
CEILING |
|
WIRING | RIDGE |
| |
| SIDE |
CROSSBAR | DOWN |
MOUNTING |
|
BRACKET |
|
FLAT
WASHER
GREEN
GROUND
WIRE
OUTLET BOX
MOUNTING
HARDWARE
| CANOPY HARDWARE |
| |
|
| CANOPY SCREW (4) | |
CANOPY |
| CANOPY LOCK WASHER (4) | |
HATCH | CANOPY | ||
|
4
